Document Type

Article

Publication Date

7-2-2025

Publication Title

SVOA Dentistry

Abstract

Introduction: Warm vertical compaction of gutta-percha is a commonly used obturation technique due to the material’s thermoplastic properties. However, gutta-percha in backfill systems is often heated, cooled, and reheated multiple times before use, potentially altering its physical properties. This study investigated whether repeated heat cycling affects the sealing ability of gutta-percha, as measured by coronal dye leakage. Methods: Forty extracted single-rooted human teeth were cleaned, shaped, and randomly divided into four groups (n = 10) based on the number of heating cycles the gutta-percha underwent prior to obturation: Group A (1 cycle), Group B (3 cycles), Group C (5 cycles), and Group D (7 cycles). All teeth were obturated using the B&L Beta Mini backfill system set to 200°C. After obturation, roots were sealed with nail polish (excluding the orifice), submerged in India ink for 7 days, then cleared using a standard decalcification and dehydration protocol. Dye penetration was measured from the orifice to the deepest apical extent using ImageJ. Statistical analysis was performed using two-tailed Student’s t-tests (P < 0.05). Results: Group A showed the least dye leakage (2.29 ± 1.07 mm). Leakage increased significantly in Groups B (4.1 ± 1.82 mm), C (5.62 ± 1.91 mm), and D (3.88 ± 1.27 mm) compared to Group A (P < 0.05). No significant differences were observed among Groups B, C, and D (P > 0.05). Conclusion: Repeated heating of gutta-percha was associated with increased coronal dye leakage. Clinicians should use caution when reusing gutta-percha subjected to multiple heat cycles to avoid compromising obturation quality.

Volume

6

Issue

4

Share

COinS